6 www.zeropointusa.com ZERO POINT PROPRIETARY 757.721.6601 Main Barrel (12”) , Breech Plug, Smooth Bore Extensions (6”), Protective Caps and Rifled Bore Extension (6”) All parts are made with 6-4 titanium alloy (grade 5). The TiTAN can be used in the following configurations: ➢ 12” Main Barrel (12”/1.75 LB), TiTAN MB ➢ 12” Main Barrel, one 6” Smooth Bore Extention (18”/2.5 LB), TiTAN S ➢ 12” Main Barrel, two 6” Smooth Bore Extentions (24”/3.25 LB), TiTAN S2 ➢ 12” Main Barrel, one 6” Rifled Bore Extension (18”/2.5 LB), TiTAN R ➢ 12” Main Barrel, one 6” Smooth Bore & one 6” Rifled Bore Extensions (24”/3.25 LB), TiTAN SR ➢ 12” Main Barrel, two 6” Smooth Bore & one 6” Rifled Bore Extensions (30”/4.0 LB), TiTAN S2R All general disruption water shots should only use smooth bore configurations: TiTAN MB (60mL of water) TiTAN S (100mL of water) TiTAN S2 (140mL of water) Ensure a protective cap is used on the last threaded section when using a smooth bore configuration. All precision disruption shots using sabot rounds should use the rifled bore configurations. NOTE: L-Tech round velocities are characterized using a 24” length barrel. Using TiTAN configurations of other than 24” will produce round or water velocities that may vary from L- Tech’s advertised technical data. O-Rings O-rings are provided for the 4 threaded sections of the smooth barrels to prevent gas venting through these areas. Prior to first use, lubricate and inspect the o-rings on the threaded sections of each TiTAN barrel and smooth bore extensions. Clean and re-lubricate as necessary.